Description

100% virgin uncooked material

Consistent colour all over complete spool

Very clear, clear and difficult material

Not more likely to cut back or warp, nice among-layer bonding

Finish prints with shiny floor and distinctive flexibility

Recommended print temperature: 220 – 260°C (Higher with heated Mattress)

Use Guide:

1. Open the bag, positioned the filament spool at the holder.

2. In finding the unfastened finish of the 3d filament, take into account that to not free the tip in case of any crossing/tangling loops.

3. Set a printing temperature according to the filament subject material, press the extruding button and spot if the melted filament extrudes easily. If the silky filament comes out lightly and simply, it implies that it’s the proper temperature; if there may be “kaka” sound, it implies that the temperature isn’t prime sufficient and you wish to have to extend the extruder temperature; if the extruding is going too simply even as the skin is tough, it implies that the temperature is simply too prime and you wish to have to decrease the extruder temperature.

4. While the print temperature is ready, you’ll be able to make a choice the type, get sliced and get started printing.

Filament Garage:

1. Please stay the filament at dry position and steer clear of direct daylight or supply of warmth.

2. While finish the usage of 3d filament, positioned the spool again into the sealed bag to steer clear of moisture.

3. While finish printing, position the unfastened finish of filament again to the spool hollow in case of crossing/tangling loops.

Completely wound filament with out tangles
1.75mm Filament Diameter (Tolerance: +/- 0.03mm)
High quality Certificates: ROHS, ISO9001
Really helpful Print Temperature: 220 – 260°C (Higher with Heated Mattress)
Spool Diameter: 7.nine” – Spool Width: 2.6″ – Spool Inside Hub Diameter: 2.2″