Description

100% virgin uncooked material

Consistent colour during complete spool

Environmental pleasant/biodegradable material

No smoke and no ugly scent throughout printing

Finish prints with clean and shinning surface

Can be used to print massive-measurement fashions with out warping

Use Guide:

1. Open the bag, positioned the filament spool at the holder.

2. To find the unfastened finish of the 3d filament, keep in mind that to not unfastened the top in case of any crossing/tangling loops.

3. Set a printing temperature according to the filament subject material, press the extruding button and notice if the melted filament extrudes easily. If the silky filament comes out flippantly and simply, it implies that it’s the fitting temperature; if there may be “kaka” sound, it implies that the temperature isn’t prime sufficient and you want to extend the extruder temperature; if the extruding is going too simply even as the skin is tough, it implies that the temperature is simply too prime and you want to decrease the extruder temperature.

4. Whilst the print temperature is about, you’ll select the fashion, get sliced and get started printing.

Filament Garage:

1. Please stay the filament at dry position and steer clear of direct daylight or supply of warmth.

2. Whilst finish the usage of 3d filament, positioned the spool again into the sealed bag to steer clear of moisture.

3. Whilst finish printing, position the unfastened finish of filament again to the spool hollow in case of crossing/tangling loops.

Completely wound filament with out tangles
1.75mm Filament Diameter (Tolerance: +/- 0.03mm)
High quality Certificates: ROHS, ISO9001
Advisable Print Temperature: 190 – 240°C
Spool Diameter: 7.nine” – Spool Width: 2.6″ – Spool Inside Hub Diameter: 2.2″